Technical Support

Frequently Asked Questions (FAQ)

Tables

EV650
T1: Why does the tabletop drive upward, but not downward?
T2: How do the covers come off when the tabletop is stuck in the down position?
T3: Why is the table not driving up or down?
T4: What is the patient load of the table?
T5: What is the “cut out” dimension at the base for cable routing?

FTT and RT100
T6: My longitudinal table top locks don’t hold, what shall I do?
T7: How do I remove the table top assembly from the table?
T8: What is the maximum patient weight of the table?
T9: How much does the table top assembly weigh?
T10: My bucky carriage lock does not work, what shall I do?
T11: What is the LED Green lite on the front of my table for?
T12: The two square holes on each side of the table base, what are they for?

	T1: Why does the tabletop drive upward, but not downward?
	There are a couple possibilities. Check if tabletop anti-collision switches are activated or if the foot treadle is wrapped and activates the treadle switch. Up ^

	T2: How do the covers come off when the tabletop is stuck in the down position?
	The tabletop must be removed then the table can be raised with provided override cable (later models) connected between motor and J105 on the Main board. Please give attention to override cable labeling. On earlier models, a 24 VDC supply with a minimum 3 amp capacity is connected to the motor. Be certain to use proper polarity. Limits do not function. Up ^

	T3: Why is the table not driving up or down?
	Check motor fuse F1 and replace as necessary. If the table locks are not working as well, check CB1 and reset as necessary. If problems persist with CB1 or F1, please contact Technical Support for further assistance. Up ^

	T4: What is the patient load of the table?
	650 pounds with the tabletop centered. Up ^

	T5: What is the “cut out” dimension at the base for cable routing?
	It is 8” x 8” square as listed in the EV650 site planning. Up ^

T6: My longitudinal table top locks don’t hold, what shall I do?

Make sure that both locks are working and you have 24VDC applied to them.
Make sure they are properly adjusted, see manual for adjusting table top lock coils.
Make sure leaf springs are not broken, if so replace them.

T7: How do I remove the table top assembly from the table?

Turn off all power to the table.
Unscrew bumper screws and remove bumpers on either end of the table top assembly.
Slide table top off the base.
Reverse steps to reassemble.

	T8: What is the maximum patient weight of the table?
	This table can support a maximum patient weight of 500 lbs (227 kg). Up ^

	T9: How much does the table top assembly weigh?
	Table top assembly weighs approximately 80 lbs (36 kg). Up ^

T10: My bucky carriage lock does not work, what shall I do?

Check the switch to see if it Ohms out good.
Check lock voltage and connections.
Replace it if necessary.

	T11: What is the LED Green lite on the front of my table for?
	This LED Green Lite indicates that you have power to the table. Up ^

	T12: The two square holes on each side of the table base, what are they for?
	They are side electrical access panels. Up ^